Ricoh BE-C1 D046, Field Service Manual, Page: 415 / 734

• You must select Tray 1 (1st Roll) or Tray 2 (2nd Roll). You cannot use "Auto Paper Select". If you
select "Auto Paper Select" the pattern will not print.
7. Set the blank sheet of paper on the original feed tray.
8. Press [Start]. The pattern prints.
9. Touch "SP Mode" to return to the SP mode.
10. Check the density of the patterns in LPH 1, LPH 2, and LPH 3.
If density is equal for all areas, no adjustment is necessary. If the density is not equal, do the next
procedure.
To Correct Pattern Density
1. Do SP2943-1, -2, and -3
• This SP makes the output of each LPH block brighter or darker.
2. Adjust the density for LPH 1 with SP2943-1.
• If the density is too dark, set a smaller value.
• If the density is too light, set a larger value.
3. Do SP4417, select Pattern #19, touch [OK], then print the pattern by feeding the blank sheet and
check the density.
4. Do this procedure for LPH2 and LPH3 until the density is the same in each of the three sections.
• LPH2: SP2943-2
• LPH3: SP2943-3
Image Position, Magnification, Margin Adjustments
Do these adjustments if the customer is unhappy about the above properties of the output. Before you do
any measurements, allow the test print output to cool for five minutes.
Important Adjustments
413
4