Ricoh Aficio SP C811DN Series, Software Manual

Page: 360 / 384

Cautions to Take When Using in a network
Connecting a Dial-up Router to a Network
When the NetWare file server and printer are on opposite sides of a router, packets are sent back and
forth, causing communication charges to be incurred. Because packet transmission is a specification of
NetWare, you need to change the configuration of the router. If the network you are using does not allow
you to configure the router, configure the printer instead.
Configuring the router
Filter packets so that they do not pass over the dial-up router.
• The MAC address of the printer doing the filtering is printed on the printer configuration page. For
details about printing a configuration page, see p.170 "List/Test Print Menu" .
• For details about configuring the printer if the router cannot be configured, see the instructions below.
Configuring the printer with NetWare
1. Following the setup method described earlier in this manual, configure the file server.
2. Set the frame type for NetWare environment.
• For details about selecting a frame type, see p.192 "Host Interface Menu".
Configuring the printer without NetWare
When not printing, the network interface board sends packets over the network. Set NetWare to "inactive".
• For details about selecting protocols, see p.192 "Host Interface Menu".
Using DHCP
You can use the printer in a DHCP environment. You can also register the printer NetBIOS name on a
WINS server when it is running. Note the following points when an Ethernet interface is simultaneously
installed.
11. Appendix
358
11