Ricoh Aficio MP 6000, Operating Instructions Manual

Page: 639 / 907

Reception
170
3
Note
❒
You can load a maximum of 100 sheets of standard paper in the bypass tray.
❒
You can use a size of paper not loaded in the paper tray(s) in the bypass tray.
❒
The machine can detect A6 L , A5 L , A4 L , A3 L (5
1
/
2
"
×
8
1
/
2
" L , 8
1
/
2
"
×
11" L ,
11"
×
17"
L
) paper sizes. When you load any other size, specify the paper size.
However, if the specified paper size and size of paper set in the bypass tray
do not match, paper jams may occur, or the image may be shortened.
❒
Documents printed on paper smaller than A4 may be shortened, or split
across sheets.
❒
Paper longer than 600 mm may be creased, not sent, or jam.
❒
Print area depends on optional expansion memory, resolution, and vertical
length of originals.
❒
If you use this function, Image Rotation and 180-degree rotating printing are
not possible.
Reference
“Facsimile Features”, General Settings Guide
Where Incoming Documents Are Delivered - Output Tray
You can specify the output tray or output position to facilitate separation of re-
ceived documents.
Specifying tray for lines
Use this function to specify the output tray for each line port.
You can specify the document feeding tray for each port (telephone, Internet
Fax, IP-Fax). For example, you can specify documents received through the G3-1
port to be fed to the “Finisher Upper Tray” and documents received through the G3-2
port to be fed to the “Finisher Shift Tray”, facilitating separation of files. You can
also set the machine to output Internet Fax documents and ordinary faxes onto
different trays.
Important
❒
The optional 3,000Sheet-50Sheet Staple Finisher or the optional booklet fin-
isher is required.
❒
The optional extra G3 interface unit is required to use the extra G3 line.
Note
❒
To use this function, specify the port and destination using [ Specify Tray for
Lines ] in the Facsimile Features menu.
Reference
“Facsimile Features”, General Settings Guide