Ricoh Aficio MP 6000, Operating Instructions Manual

Page: 533 / 907

Transmission
64
1
Specifying a Destination
This section explains how to specify a destination.
Fax numbers, IP-Fax destinations, and e-mail addresses can be specified.
Note
❒
The display shows the percentage of free memory space for storing originals.
Since fax numbers, IP-Fax destinations and e-mail addresses are programmed
in separate memory, dialing fax numbers using the number keys does not
change the percentage on the display.
Sending Over a Fax Line
Enter numbers directly using the number keys on the right side of the control
panel.
A
Make sure that [ Fax ] is selected.
B
Enter the fax number using the number keys.
If you make a mistake, press the
{
Clear/Stop
}
key, and then enter again.
If the optional extra G3 interface unit is installed, select the line you want to
use before pressing the
{
Start
}
key.
To select a destination from the Address Book, see “Using the Address Book
to Specify Destinations”.
C
Press the
{
Start
}
key.
The machine starts to scan the original and stores it in memory. When scan-
ning ends, the Communicating indicator lights and transmission starts.
Note
❒
You can insert pauses and tones in a fax number.
❒
Press [ Prg. Dest. ] after entering the fax number to store the fax number in
the destination list.
❒
For the maximum number of digits for a destination, see “Maximum Values”.