Ricoh Aficio MP 2500, Facsimile Reference Manual

Page: 58 / 204

Transmission
48
1
B
Enter the fax number using the number keys.
C
Press [ Tone ] .
D
Enter the number you want to tone dial using the number keys.
E
Press the
{
Start
}
key.
The transmission starts.
If you want to cancel a transmission, press the
{
Clear Modes
}
key, and then re-
move the originals.
After transmission, the standby display appears.
Note
❒
Certain services may be unavailable even when using the Tone function.
❒
A tone is shown as a “T” on the display and the next numbers are dialed using tonal signals.
Sending by IP-Fax
This section explains how to specify a destination using IP-Fax transmission.
When using IP-Fax transmission, specify the IP-Fax destination (IPv4 address,
host name, or alias telephone number) in place of the fax number.
Important
❒
To use IP-Fax functions, the optional printer/scanner unit must be installed.
❒
To send an IP-Fax document, in the Fax Features menu, configure the IP-Fax Settings as
follows. For details about IP-Fax Settings, see “Fax Features”, General Settings Guide.
• If you are using a gatekeeper server, set
[ Enable H.323 ] to [ On ] and configure
the gatekeeper settings under [ H.323 Settings ] .
• If you are using a SIP server, set [ Enable SIP ] to [ On ] and configure the SIP
server settings under [ SIP Settings ] .