Operation
©
Rice Lake Weighing Systems
●
All Rights Reserved
19
3.0 Operation
3.1 Operation Front Panel
3.1.1 POWER Button
Press the POWER button to turn on the printer, and the
Start Up Screen
appears. The printer is on
Ready to Print
status, the
LCD screen should display the message
READY
on the screen. When printer is on, hold and press down the POWER button
for 3 seconds to turn the printer off.
3.1.2 FEED Button
Turn on the printer and press the FEED button. When the FEED button is pressed, the printer advances media until the FEED
button is released. If using continuous labels, pressing the FEED button advances a length of media until the button is released.
If using media with gaps, pressing the FEED button once advances only one label.
NOTE: If the label does not stop at the correct position, run the auto-detection function for the media being used, please
Pause Printing
Pressing the FEED button while the printer is in standby mode to set the printer to pause mode. In this mode, the printer can
receive commands, but it only processes them when it is reset to standby mode. Pressing the FEED button again resets the
printer to standby mode. Pressing the FEED button during printing interrupts printing. When the FEED button is pressed again,
the printer resumes printing.
Example: While a 10-label print job is running, press the FEED button to pause the printer. If two of the labels have been
printed, press the FEED button again to resume printing and print the remaining eight labels.
Cancel Printing
Press and hold the FEED button for 3 seconds during printing cancels a print job. The current print job is canceled.
Example: While a 10-label print job is running, press the FEED button to cancel the print job. If two of the labels have been
printed, the remaining eight labels will not be printed.
OPERATION
FRONT PANEL
POWER BUTTON
FEED BUTTON
TOUCH PANEL
