48
SCT-1100 Weight Transmitter
30. Press
to confirm.
displays.
31. Press
until the instrument displays
.
32. Press
to
confirm.
displays momentarily and the instrument reboots.
5.5.2
Dependent Channels
Use this procedure to perform a theoretical calibration on a scale in the
functioning mode
1. Turn on the instrument and press
while the firmware version displays.
displays.
2. Press
and then press
or
until
displays.
3. Press .
displays.
4. Press
or
until
displays.
5. Press .
displays.
6. Press .
displays.
7. Press
and then press
or
to set the number of connected channels (
-
)
8. press
to confirm.
displays.
9. Press
or
until
displays.
10.
Press .
displays.
11.
Press
and
then
press
or to set the decimal (
,
,
,
).
12. Press to
confirm.
displays.
13. Press
and then press
or
to set the weight unit (
,
,
,
).
14. Press
to
confirm.
displays.
15. Press
and then press
or
to set divisions (
1
, 2, 5, 10, 20, 50).
16. Press
to confirm.
displays.
17. Press
. The rightmost digit flashes.
18. Press
to select the digit to be modified and
or
to decrease or increase the digit to set the total
capacity of the scale or the first range in case of multi-range functioning.
19. Press
to
confirm.
displays.
20. Press
and then press
to select the digit to be modified and
or
to set the second range or set
to all zeros, if only one range.
21. Press
to confirm.
displays.
22.
Press
or
until
displays.
23. Press
to confirm.
displays.
24. Press
and then press
to select the digit to be modified and
or
to set cell sensitivity.
25.
Press
to confirm.
displays.
26. Press
and then press
to select the digit to be modified and
or
to set cell capacity.
27. Press
to confirm.
displays.
28. Press
and then press
to select the digit to be modified and
or
to set the dead load. If
unknown, enter all zeros.
*Cell Sensitivity - if several load cells are connected through a junction box enter the average sensitivity
value of the cells.
*Cell Capacity - if several load cells are connected through a junction box, enter the sum of the load cells.
*By setting the value to zero, the dead load is acquired.
29.
Repeat this procedure for each connected scale.
C
Note
