Rice Lake SCT-1100, Technical Manual

Page: 30 / 88

26 SCT-1100 Weight Transmitter
The instrument repeats the data of the display or the weight string of the instrument to which it is connected, once
the serial string of the connected instrument is identified.
Keys pressed on the repeater are not duplicated on the transmitter and vice versa.
The instrument acts only as a weight repeater; is the only key enabled and turns the instrument on/off.
In the single scale repeater mode only the

transmission mode is enabled for the printer port. See
Section 6.3 on page 55 .
Example of settings for repeater/transmitter configuration:
3.10.7 Sensitivity Times Ten
This mode converts the weight to sensitivity time ten for display and is used for testing during calibration.
Operation
1. Press to toggle the weight display between standard sensitivity and sensitivity times ten.The last digit
on the right of the display has a sensitivity equal to the scale’s division divided by 10.
2. Press and hold to enter the setpoint input menu . See Section 4.3 on page 41 .
If the
  
is set as

the 10X display is possible only with capacities over 220 lb.
Printout and change of channel can only be performed when the instrument is in the standard sensitivity.
3.10.8 Hold the Weight on the Display
This mode allows the operator to hold a weight on the display.
1. Press to hold the weight on the display.  displays alternately with the weight value.
2. Press again to release the weight value.
3. Press and hold to enter the setpoint input menu. See Section 4.3 on page 41 .
Exit the hold mode to toggle from one scale to another when multiple scales are connected to the instrument.
3.10.9 Peak Weight Detection
This mode can be used to store the maximum (peak) weight value measured during the weigh.
Operation
1. Press to enable the peak weight detection.  displays alternately with the maximum weight
value reached up to that point.
2. Press again to terminate the peak weight detection. Peak weight detection also terminates if the weight
surpasses the maximum capacity of the instrument. In both cases,

displays and then the current
weight on the scale displays. The detected weight value will be:
• The maximum before a rapid decrease of the weight (measurement of the ultimate load)
• The maximum and persistent weight detected on the scale
3. Press and hold to enter the setpoint input menu. If an output setpoint has been configured, it is
possible to enter a submenu and choose a parameter to modify. Select

( Section 4.3 on page 41 )
Exit the peak mode to toggle from one scale to another when multiple scales are connected to the instrument.
Setting Sampling Time
To set the minimum sample time of the peak weight detection:
1. Press and hold .
2. If an output setpoint has been configured, it is possible to enter a submenu and choose a parameter to
modify. Select  ( Section 4.3 on page 41 ) .  displays followed by a number which corresponds
Unit
   
Repeater
 
9600 n-8-1
Transmitter All modes except
 
9600 n-8-1
Table 3-3. Set Up Example
IMPORTANT
C
Note
Note
Note