Rice Lake REVOLUTION 682 Synergy Plus, Technical Manual

Page: 87 / 130

Fieldbus Options Configuration
© Rice Lake Weighing Systems ● All Rights Reserved 79
10.6.1 Onboard Digital I/O Status
10.6.2 Calibration Status
10.6.3 Command Status
The following values named Result of last command received , needs updating after the last command processed value
is updated.
Table 10-6. Onboard Digital I/O Status
Bit Description Bit Status
0 Digital I/O Bit 0 = Off 1 = On
1
2
3
4-31 Future Use
Table 10-7. Calibration Status
Value Description
0 Calibration not started
1 Calibration Acquisition in process
2 Calibration Acquisition OK
3 Calibration error
Table 10-8. Command Status
Bytes Description
0-3 Current command status result
Table 10-9. Command Descriptions
Value Description
0 Command successfully performed
1 Not a valid command
2 General error; Trying to tare or zero while scale is in motion
3 Setpoint number does not exist; When trying to read or write to a setpoint but the setpoint
value does not exist
4 Setpoint Kind set to OFF; When trying to read or write to a setpoint, but that setpoint is
not configured
5 Setpoint not enabled; When trying to read or write to a setpoint but the setpoint is not
enabled
6 Invalid IO; When trying to set any output on or off and that output is not configured
7 Not in Setup mode; When trying to use write setup, zero calibration, span calibration,
point calibration, save calibration or abort calibration commands
8 Wrong command; Non-calibration command used during calibration
9 Invalid unit selection
10 Invalid decimal selection
11 Invalid display division selection
12 Calibration point out of range (1–4)
13 Invalid grads value
14 Calibration not allowed for MRMI or serial scale
15 Calibration weight out of range
16 Accumulator is not enabled
17 Audit trail is not enabled; Check the jumper to see that it is in the correct position