Rice Lake REVOLUTION 682 Synergy Plus, Technical Manual

Page: 69 / 130

Truck Modes
© Rice Lake Weighing Systems ● All Rights Reserved 61
7.3 Weigh-In Procedure
In modes 1 and 2, the indicator erases truck ID numbers and tare weights from memory after the transaction. In modes 3–6,the
truck ID and weigh-in weight values are saved after the weigh-out ticket has been processed.
The general weigh-in procedure is as follows:
1. The empty truck moves onto the scale for weigh-in.
2. Press the
Weigh In softkey. The keyboard truck ID entry screen displays.
3. Enter the truck ID (up to 16 characters) using the alphanumeric entry procedure ( Section 3.3.2 on page 20 ).
NOTE: The numeric keypad can be used to enter numbers for truck IDs.
4. Press
Cancel
softkey to exit without saving.
- Or -
Press
Save
softkey to save and exit when the truck ID is correct.
5. Display returns to Weigh mode and the indicator prints a weigh-in ticket.
ID 304812
GROSS 15000 LB INBOUND
01/14/20 22 10:24 AM
6. Truck leaves the scale.
7.4 Weigh-Out Procedure
The general weigh-out procedure is as follows:
1. The loaded truck moves onto the scale for weigh-out.
2. If truck ID is known, press the
Weigh Out softkey, enter the truck ID, and press
Save
softkey.
If truck ID is not known, press the Truck Regs softkey to view list of stored truck IDs ( Figure 7-3 on page 60 ). Scroll to
the correct truck ID, note the truck ID, then press the Cancel softkey to return to the Weigh mode. From Weigh mode,
press Weigh Out softkey, key in the truck ID, then press
Save
softkey.
3. Display returns to Weigh mode and the indicator prints a weigh-out ticket. In modes 1 and 2, the truck ID is deleted
once the weigh-out ticket is processed.
7.5 Single-Transaction Tare Weights and IDs
One-time transactions are supported in all modes that can be configured to use stored Truck IDs (modes 3–6). This function
allows one-time weighing of trucks without adding the truck ID and weigh-in weight to the permanent truck register.
To use this function, press the
Weigh In or Weigh Out softkey, then enter a truck ID containing a decimal point. Truck IDs
entered with a decimal point as part of the truck ID are erased from the truck register when the transaction is complete.