Rice Lake Legend 480-2A, Technical Manual

Page: 49 / 85

42 480 Legend Series
3.2.7 Analog Output Menu
If the analog output option is installed, configure all other indicator functions and calibrate the indicator (see
Section 4.0 on page 46) before configuring the analog output. See Section 9.12 on page 70 for analog output
calibration procedures.
Figure 3-15. Analog Output Menu
Parameter Choices Description
SOURCE GROSS
NET
Specifies the weigh data, gross or net, tracked by the analog output.
OFFSET 0
20
Zero offset in %. Select 0% for 0–10 V / 0-20 mA; select 20% for 2-10 V / 4-20 mA output.
Set OFFSET after calibrating 0-20 mA.
ERRACT
FULLSC
Error action – specifies how the analog output responds to system error conditions.
Set to full value (10 V or 20 mA).
HOLD Hold current value.
ZEROSC Set to zero value (0 V or 0 mA) or (2 V or 4 mA)
MIN 000000
0 – 999999
Specifies the minimum weight value tracked by the analog output. Specify a weight value (in
primary units) in the range 0
– 999999.
MAX 010000
0 – 999999
Specifies the maximum weight value tracked by the analog output. Specify a weight value (in
primary units) in the range 0
– 999999.
MINNEG NO
Yes
YES implies that the value in MIN is a negative value. NO is the default and implies that MIN is
a positive value.
MAXNEG NO
Yes
YES implies that the value in MAX is a negative value. NO is the default and implies that MAX is
a positive value.
TWZERO 000000
0 – 65535
Tweak zero – adjust the analog output zero calibration. Use a multimeter to monitor the analog
output value. Press
or to select the digit to edit. Press or to edit the selected
(flashing) digit. Press to save the new value.
TWSPAN 000000
0 – 65535
Tweak span – adjust the analog output span calibration. Use a multimeter to monitor the
analog output value. Press
or to select the digit to edit. Press or to edit the
selected (flashing) digit. Press to save the new value.
OUTPUT
CURENT
Defines the output type.
0-20 mA or 4-20 mA, depends on OFFSET .
VOLTAG 0-10 V or 2-10 V, depends on OFFSET .
Table 3-16. Analog Output Menu Parameters
CONFIG FORMAT CALIBR PROGRM DIG IN ALGOUT PASWRD USBMEM MENU TEST
SOURCE
NET
GROSS
MIN
000000
MAX
010000
OFFSET
0%
20%
ERRACT
FULLSC
HOLD
ZEROSC
TWSPAN
000000
TWZERO
000000
MINNEG
NO
YES
MAXNEG
NO
YES
OUTPUT
CURENT
VOLTAG