Rice Lake Legend 480-2A, Technical Manual

Page: 48 / 85

Configuration Using the Front Panel (Legal for Trade) 41
3.2.6 Digital Input Menu
Figure 3-14. Digital Input Menu
Parameter Choices Description
DIGIN1
DIGIN2
DIGIN3
DIGIN4 Specifies the function activated by digital inputs 1, 2, 3 and 4.
OFF Sets the Digital Input to perform no function.
ZERO Same function as the front panel key.
TARE Same function as the front panel key.
NT-GRS Net-Gross – same function as the front panel key.
UNITS Same function as the front panel key.
DSPTAR Displays the current tare value.
PRINT Same function as the front panel key.
CLRCN Resets the consecutive number to the value specified on the CONSTU parameter (PROGRM
menu).
KBDLOC Disables the keypad while the digital input is held active.
HOLD Holds the current display. Releasing this input returns to normal display update mode.
CLRTAR Clears the tare.
ACCUM Displays the accumulator.
CLRACC Clears the accumulator.
BATSTR Starts a batch process.
BATSTP Stops a batch; any restart starts the batch at the beginning.
BATRES Resets the batch process so the pointers are aimed at first batching setpoint.
BATPUS Pauses a batch, but allows it to restart at the point where it was paused.
BATRUN A switch that allows a batch to be started. It must be active to allow any batch to run.
If not active, and a BATSTRT input is activated, the batch will abort or reset.
NET Puts the scale in net mode.
GROSS Puts the scale in gross mode.
PRI Puts the scale in primary units.
SEC Puts the scale in secondary units.
Table 3-15. Digital Input Menu Parameters
DIGIN1-4
OFF
PRINT
ZERO
TARE
NT-GRS
UNITS
DPSTAR
CLRCN
CONFIG FORMAT CALIBR PROGRM DIG IN ALGOUT PASWRD USBMEM MENU TEST
KBDLOC
BATSTR
BATSTP
BATRES
HOLD
CLRTAR
ACCUM
CLRACC
BATRUN
BATPUS
NET
GROSS
PRI
SEC