Rice Lake CLS-920i, Installation Manual

Page: 11 / 97

6 CLS-920i Installation Manual
1.3.5 Softkey Operations
Softkeys can be defined to provide additional operator functions for specific applications. Softkey assignments are
listed on the tabs shown at the bottom of the LCD display; softkey functions are activated by pressing the
arrow
keys
below the softkey tabs (Figure 1-2 on page 4).
The particular set of softkeys shown on the display is determined by the indicator configuration and program.
Table 1-1. Configurable Softkeys
Softkey Description
Time/Date Displays current time and date; allows time and date change.
Display Tare Displays tare value for the current scale
Display Accum Displays accumulator value, if enabled, for the current scale.
Display ROC Displays rate-of-change value, if enabled, for the current scale.
Setpoint Displays a menu of configured setpoints; allows display and change of some
setpoint parameters.
Batch Start Starts a configured batch.
Batch Stop Stops a running batch and turns off all associated digital outputs. Requires a batch
start to resume processing.
Batch Pause Pauses a running batch. (Same as stop, but digital outputs, if on, are not turned
off.)
Batch Reset Stops a batch and resets it to the first batch step.
Weigh In Allows truck ID entry; generates weigh-in ticket for truck weighing applications.
Weigh Out Allows truck ID entry; generates weigh-out ticket for truck weighing applications.
Truck Regs Displays truck register; allows deletion of individual or all entries. Truck register can
be printed by pressing the
PRINT key while the truck register is displayed.
Unit ID Allows display or change of Unit ID.
Select Scale For multi-scale applications, provides a prompt to enter the scale number to be
displayed.
Diagnostics
Provides access to diagnostic displays for the attached two channel
iQUBE
.
F1–F10 User-programmable keys; defined by application.
More… For applications with more than five defined softkeys, the More… key is
automatically assigned to the fifth softkey position. Press More… to toggle
between groups of softkeys.
1.4 Accepting Weight Data to the Indicator
The 920i can accept data in two different ways from the two-channel iQube and depending upon which version of
the CLS-920i is purchased, will come with different components. They are:
• Wired - Coil Cable
Figure 1-3. Coil Wired Signal Cable That Runs Between the 920i Indicator and the Two-Channel iQube
• Wireless - Attached onto the back of the 920i HMI digital weight indicator and collects data from the
two-channel iQube without the use of a coil wire cable but instead uses a lithium-ion battery which is
housed on the scale itself for power.