Starting and stopping the equipment
- Put the plug into a socket and press the switch. The product will start operating.
- The vacuum power can be regulated by sliding the regulating switch.
Vacuuming liquids
- Before vacuuming liquids, put the sponge filter in place. The product is provided with a float
device and sponge filter to protect the motor from the vacuumed liquids.
Blowing function
- Insert the suction pipe into the upper hole on the bin and tighten securely.
In this way, the blowing function of the product can be used.
CLEANING AND STORAGE
Before carrying out any operation, make sure the product is not connected to the mains.
ADDITIONAL INSTRUCTIONS FOR THE USE OF THE POWER TOOL SOCKET:
In order to use your vacuum and the power tool socked proceed as follows:
a) Open the protection cap of the socket
b) Insert the plug
c) Activate the switch. At this point vacuum and power tool can operate simultaneously.
Never suck up liquids when using a power tool but only solids
Cleaning
Clean the plastic parts using just a suitable soft cloth. Do not use aggressive products (solvents,
cleansing agents), or abrasive sponges, sharp objects or those with cutting edges.
Never immerse the product in water or in any other liquid.
Cleaning the bin:
After vacuuming or when the bin is full of dust/liquid, the suction power decreases considerably.
In this case, the plug must be removed and the bin emptied. To do this, release the two hooks,
remove the top lid, the sponge filter and the cloth filter. Then empty out the dust or liquid. Replace
the top lid and secure it in place with the two fastening hooks.
Storage
Store in a dry place under lock and key or out of children’s reach.
