- This product can be used only by trained adults. This product is not suited for use by:
people (including children) with impaired physical, sensorial, or mental capacities and people lacking in experience and
skill unless they are supervised or instructed in the use of the product by a person responsible for their safety.
- The product must never be used if it is damaged, off-centered, or vibrating.
- The product must always be gripped firmly.
- Never allow your hands to come close to the accessories during operation.
- Always make sure that the product has come to a stop before setting it aside.
Note: the accessories must not be moving when the product is set aside.
- Never use the product on materials that contain asbestos.
- Warning: The use of accessories other than those recommended in the operating instructions may pose the risk of injury
to people and animals and damage to property. The user and/or operator of the product are the only parties responsible for
such damage and/or injury.
- Note: The safety recommendations and instructions provided in this manual do not illustrate all the work conditions and
situations that may arise in their entirety. The user and/or operator must use the product with good sense and prudence in
regard to all aspects not covered by this manual.
Residual risks:
Even when the product is used as specified, not every residual risk can be eliminated.
PREPARATION AND USE OF THE BATTERY-OPERATED BRUSH
1. TO START
1.1- Unpacking
- Remove the product from the packaging.
- Make sure that the appliance has not been damaged.
- Content:
1 battery-operated brush body
1 metal brush
1 charger
1 USB cable
1 user and maintenance manual
1.2- Assembly
Assemble the accessories (in this case, the metal brush provided) as shown in the figures below in the following steps:
-
Grip the product’s body firmly as shown in Figure A
-
Fit the accessory into the product’s body as shown in Figure B
-
Gripping the product’s body firmly, screw the accessory counter-clockwise until it clicks as shown in Figure
C.
No other assembly adjustment is required.
