RHINO FC-0110, Operator'S Manual

Page: 130 / 166

MAINTENANCE
TR308 04/21 Maintenance Section 5-24
M
A
IN
TE
N
A
N
C
E
© 2021 Alamo Group Inc.
DISASSEMBLY AND ASSEMBLY PROCEDURES FOR T-BOX
Refer to Figure Mnt-R-0118 for location of all item numbers in procedures.
Remove Main Input Shaft
Step I.
Drain oil from gearbox. Place gearbox on appropriate work surface. Remove the 8 bolts (3) retaining the Input
housing hub. Remove hub assembly from main housing. Note quantity and thickness of shims between hub
and main housing.
Step II.
Remove cotter pin (14) and adjusting nut (13).
Step III.
Remove gear (17). Press on threaded end of shaft (16) to remove from hub.
Step IV.
Remove bearing cone (8) from shaft (16).
Step V.
Remove bearing cups (8) from hub housing.
Step VI.
Remove 8 bolts (10) from on side cap (2). tap on opposite side shaft end (6) to remove side cap (2) and on side
shaft assembly.
Step VII.
Remove 8 bolts retaining remaining side cap (2) in place. Using end of hammer handle tap inside of cap to
remove from main housing, Note quantity and thickness of shims under both side caps.
Also mark side cap which was closest to gear and main housing, so it may be reassembled later in same
location.
Step VIII.
Lap shaft ends on solid metal surface to remove bearings (8), gear (3), and spacer (4)
Gearbox is not completely disassembled. Inspect and replace all worn or damaged parts.