Rhin-O-Tuff OD4012, Instruction Book

Page: 8 / 50

6
Providing power to the machine:
u
Power cord shall be certified for the country
where the machine will be installed.
Plug one
end of the power cord into the power cord
receptacle on the back of the machine. The
other end goes into the wall outlet.
Die Installation:
u
u
u
u
u
Diagram 2.
.
Make sure there is no paper dust or paper chips
in the machine die slot before installing the die.
Install the die by sliding it into the opening
located on the left hand side of the machine. Make sure the punch pin
retainer slides into the slot on the backside of the opening.
Install die until right side of die is flush to exterior of right side of
machine.
Thread both retained die lock knobs into the die and tighten evenly
until the die can not move.
Make sure the machine is turned
off before installing the die
Diagram 2. (Image of OD4012)
! DANGER
Hazardous voltage.
Use only approved
power cord
assemblies.
!
WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.
Die Lock Knob
Punch Pin
Retainer