Rhin-O-Tuff OD4012, Instruction Book

Page: 12 / 50

10
Paper Jam:
u
The OD4012 punch uses a circuit board for controlling the punch
cycle, this circuit board also has the ability to automatically reverse the
pusher bar and punch pins to their starting position if the machine
takes too much time to complete a punch cycle. This condition could
happen if too much material has been attempted to be punched at one
time. If this condition occurs, allow the machine to attempt to reset
itself back to its home position.
u
If the punch does not reset itself back to its home position, the punch
will need to be reversed manually.
! WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.
u
Turn the machine power switch off and
remove some or all of the material in the
punch.
It is easier to remove one or two sheets at a time from the
backside of the material in the punch.
u
OD4012 Manual Reverse utilizes a reversing
tool supplied with the punch.
Locate the
silver plug on the rear of the left side panel of
the machine. Remove the silver plug by prying it out gently with a
small flat tool. Insert the end of the reversing tool into the open hole
and engage the tool with the end of the motor shaft. Rotate the tool
counterclockwise 5-10 revolutions, until the punch pins have been
retracted back to the starting position. Remove most or all of the
material from the punch. Remove the reversing tool from the punch
and replace the small silver plug. Plug the power
cord back into the wall outlet and turn the power
switch on. Test cycle the machine by punching
with no material in the punch, the machine will
reset itself back to its home position. Reduce the
amount of material being punched and continue
working.
Turn the
machine power switch off and unplug
the power cord from the wall.
! WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.