Rhin-O-Tuff OD4012, Instruction Book

Page: 11 / 50

9
Setting the paper stop/guide:
u
u
OD4012-
Locate the paper stop on the front cover of
the machine. Loosen the knob
counterclockwise, so that the guide can be
adjusted to the left or the right.
until the punch
pattern is centered on the paper.
The OD4012 punch machine allows for viewing of the common
size paper position markings on the die assemblies. Aligning
the paper stop with these marks will result in the punch pattern
being centered on the paper and need only small adjustments if
at all.
Move the
paper stop until the desired position is
reached and tighten the knob clockwise
until tight to lock the paper stop in place.
Repeat this procedure
Punching Paper:
u
Select an appropriate number of sheets to be punched and slide the
sheets down vertically into the opening of the die assembly. When the
paper is fully inserted, slide it to the left so it comes in contact with the
paper stop. Make sure all the edges of the sheets are flush by tapping
the top and the right hand sides of the sheets then activate the punch
by depressing the foot-pedal.
If a paper activated switch is being used, tap the sheets flush
before sliding the paper to the paper stop.
Removing Paper Waste:
u
The paper waste drawer is located conveniently on the front of the
punch. The paper waste drawer is removed by lifting up on the front
and pulling out away from the machine. This drawer should be
checked frequently while punching and emptied as necessary.
Paper Stop