43
LIGHTING THE WATER HEATER
FOR YOUR SAFETY READ BEFORE LIGHTING
Warning:
This
gas water heater is designed to operate reliably and safely as
long as the operating instructions are followed
exactly
. You must comply with
these lighting instructions at every stage.
Make sure the water heater is filled with water and the water supply is on,
otherwise serious damage to the stainless steel cylinder and water heater
components may occur.
The installer must check all gas connections for leaks, gas supply pressure and
test point pressure (refer rating label). Remove the access cover at the front of
the water heater to access the gas control (thermostat).
Note:
AS 3498 requires that a water heater provides the means to inhibit the
growth of Legionella bacteria in potable water. This water heater can satisfy this
AS 3498 requirement provided it is operating and the thermostat setting is 60°C
or higher, including when it is used as an in-series booster water heater for a
solar water heater.
SAFETY INFORMATION
A.
An igniter button is used to light the pilot. When lighting the pilot follow the
lighting instructions exactly.
DANGER:
Never press the igniter button while the gas control knob is
in a numbered position. Before pressing the igniter button, turn the gas
control knob to the “
” (off) position and wait five (5) minutes.
B.
BEFORE LIGHTING
ensure there is no smell of gas near the water heater
and the burner opening. Be sure to smell next to ground level as some gases
can settle there.
C.
IF YOU SMELL GAS
:
Do not try to light the water heater.
Turn the gas control knob clockwise to the “
” (off) position, then turn off
the isolation valve in the gas line to the water heater.
Leave the area and call Rheem Service or a qualified service technician.
D.
Use only your hand to turn the gas control knob, never use tools. If the
control knob will not turn by hand, call a qualified service technician. Force
or attempted repair may result in a fire or explosion.
E.
If the water heater has been damaged DO NOT attempt to operate it - call
a qualified service technician.
F.
DURING LIGHTING:
Ensure you KEEP YOUR FACE higher than the gas
control at all times.