PARTS INCLUDED
A [2] Side Panel
B [1] Front Panel
Headboard
D [1] Storage
E [4] Slats
F [2] Patform Panels
TOOLS NEEDED:
Phillips Screwdriver (not included)
ASSEMBLY INSTRUCTIONS
1. Stand the Headboard (C) upright and hook Side Panels (A) into Headboard (C) as
shown in the Diagram I.
3. Hook the Front Panel (B) into Side Panels (A) as shown in Diagram III.
4. Place the Slat (E) into the cleats on the inside of the Headboard (C) and Front Panel (B).
Screw the ends of the Slats (E) to the cleats using Screw (1), as shown in Diagram IV.
5. Lay the Patform Panels (F) flat on top of the Slats (E),as shown in Diagram V.
[1]
C
Page 1 of 2
CARE INSTRUCTIONS
Spot clean only with a soft, damp cloth ,
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
A
C
D
E
F
B
2. Attached the Storage (D) to Side Panels (A) as shown in Diagram II.
