Address
：
S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen, Fujian Province, P.R.C
Tel: 00865925771197 Fax: 00865925771202
Email: [email protected] http://www.rgblink.cn
11
How to Save the Preset Input and Output Channel
1. Push the [SAVE] button on the front panel, the button light is on. At the same time, some
buttons [1]~[8] in output and input area are on and some flash. Button is on can be saved,
and button flashes will be overwrite.
2. Choose the button on to save, the LED screen will show save complete.
3. If choose the button flash, the information saved before will be overwrite.
4. Push the [TAKE] button to confirm, and push [MENU] button to cancel.
5. Push the [MENU] to exit the save state, or push the [SAVE] button, the light is off, and exit
the save state.
Note:
The buttons [1]~[8] on output area corresponding to save 1~8, and the buttons [1]~[8]
on output area corresponding to save 9~16.
How to Load the Saved Input and Output Channel
1. Push the [LOAD] button on the front panel, the button light is on. At the same time, some
buttons [1]~[8] in output and input area are on and some flash. Button on is ready for recall,
and button flashes means just recall. Push the button on to recall.
2. Push the [MENU] button to exit the load state, or push the [LOAD] button, the button light is
off, and exit the load state.
How to Reset the Factory Settings
1. Push the [MENU] button on the front panel, and enter to the menu items.
2. Push the [MENU] up arrow button or [NEXT] down arrow button, and choose [RESET].
3. Push the [TAKE] button to confirm.
4. Push any key to reset factory settings, and push the [MENU] button to exit.
