8 |
P a g e
R F M O G U L 3 6 0 4 V i a T e r r a S t S a l t L a k e C i t y , U T 8 4 1 1 5
R e v 5 / 2 0
S a l e s : 8 0 1 - 8 9 5 - 3 3 9 2 s a l e s @ r f m o g u l . c o m
Wiring (Dish Mount Connector Box)
Note: Before Installing the Dish Reflector (parabolic antenna) to the Antenna Mount it will be
easier to complete the system Wiring. Prewiring the Antenna will allow you to raise the Dish
Arms to make installation of the Dish easier.
The RF (Coax) cabling is wired from the Feed Assembly to the Connector Box located on the
Base Mounting Plate. The Black Coax is the Receive cable connected to the LNB and the cable is
usually labeled with RX at the Base. The White Coax is the Transmit cable connected to a BUC
(Block Up Convertor) or an HPA (High Powered Amplifier).
In addition to the Coax Cables the Mount is also prewired with a 12-conductor control cable
which connects to motors, sensors, and GPS modules.
Typical Connector Box on RFM Antenna - Roof Mounting Plate
A.
Antenna Control Cable Connection. Snap together Male (33482-1201 Molex) Antenna Side and
Female (33472-1201 Molex) Control Cable to ACU-2 Antenna Controller.
B.
RX Cable to ACU-2 Antenna Controller. From LNB Black RG-6 Coax Cable. Labeled RX.
C.
TX Cable to Modem (if installed) or HPA Out. To BUC White RG-6 Coax Cable. Labeled TX.
