Revision: VCS-VCT-DE5 (12-22) 270689-A
WIND AND RAIN HOOD KIT (PN 270615) INSTALLATION FOR
HARSH ENVIRONMENT GAS-FIRED RADIANT HEATERS
Supersedes: I-VC-WH-FC (09-14) PN270689R1
OPTION DE5 FOR MODELS VCS AND VCT
⚠ DANGER ⚠
This kit is to be installed by a qualified service agency in accordance with these instructions and in
compliance with all codes and requirements of authorities having jurisdiction. Improper installation,
adjustment, alteration, service, and/or maintenance can cause property damage, injury, or death.
The qualified agency performing this work assumes responsibility for this installation.
⚠ CAUTION ⚠
It is essential that when fitting the wind and rain hood kit that waterproof sealant is used where
indicated.
•
Refer to the installation manual provided with the unit for important safety information.
•
Ensure that all components listed in
are available before beginning installation.
INSTALLATION
1. Turn OFF gas and disconnect electric power.
2. Remove screws that secure fresh air inlet plate (see
, DETAIL A) and carefully pry off plate, which is
adhered with sealant, taking care not to damage burner casing.
3. Apply full circle bead of waterproof sealant to inner flange of outdoor air spigot shown in
DO NOT DESTROY. PLEASE READ CAREFULLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
Table 1. Wind and Rain Hood Kit (PN 270615) Components
Component
Description
PN (Quantity)
Cover
Wind and rain hood, 4-inch, SST
270617 (1)
Spigot
Outdoor air
270616 (1)
Screw
Spigot, 5 mm diameter × 16 mm long, SST
270435 (3)
Self tapping, panhead, #8 × 1/2, SST
270414 (2)
Figure 1. Fresh Air Inlet Plate and Outdoor Air Spigot
DETAIL A
DETAIL B
