RD 500 RD51
Electrical Installation of Converter
4-11
DOK-RD500*RD51*******-IB04-EN-P
Terminal Layout Diagram, Size Classes C, D
A converter, size C (270 mm wide) is illustrated in the terminal layout
diagram. The position of the terminals is essentially the same for the
narrower or wider drive units. The line supply, DC link and brake resistor
terminals are always at the top and the motor connection at the bottom of
the housing.
Note:
The additional function 24 V Stand-by power supply (terminal
X83) is only mounted if it was actually ordered.
C D F
U1 V1 W1
U6 V6 W6
AN510005EN02.FH9
ALARM
ON
READY
HighVoltage.Dangerof
electricalshock.Donottouch
electricalconnectionsfor 5
minutesafterswitching
poweroff.
Readandfollow"Safety
InstructionsforElectrical
Drives"manual,DOK-GENE-
RL-DRIVE******-SVS...
beforeoperating
DANGER
ESC
START
STOP
MON
ENTER
PROG
drive 500
REFU
-
+
ALARM
ON
READY
ESC
START
STOP
MON
ENTER
PROG
-
+
X1
line connection,
DC-Link-,
Brake resistor connection
Control- and
Signal cables
X80
starting lock-out
X2
motor connection
X83
24V Stand-by power supply
U2 V2 W2
C3 D3
PE
1)
2)
X81
3)
view "X"
X83
1
2
view "X"
zoomed
1 2 3 4
1)
2) if required
3)
1):
Only with additional function L1
2):
Only with additional function F1
3):
Only with additional function C1 / D1
Fig.: 4-2
Terminal layout diagram, classes C, D
Summary of Contents for RD 500 Series
