REXROTH RD 500 Series, Applications Manual

Page: 244 / 276

8-28
Parameter Value Assignment RD 500 RD51
DOK-RD500*RD51*******-IB04-EN-P
Diagnostics / drive data
Para-
meter
No.: Name Description / explanation
selectable options
Factory setting
min ... max values
Pass-
word
0028 Operating hours 0 h -
Operating hours with the inverter enabled. 0 ... 2147483647 h
0029 Operating minutes 0 h -
Operating minutes with the inverter enabled. 0 ... 59 min
0024 Continuous current
0025 Peak current, long
0046 Peak current, short
0022 Continuous output
0023 Peak output, long
0099 Max. o/p frequency
0027 Max. normaliz. freq.
Device data correspond to the drive converter
performance data
0
0000 Firmware FWC 0 0
0001 Device ID 501
0002 Firmware version e.g. 2
0003 Firmware module e.g. 4
0004 Firmware revision e.g. 1
0005 Firmware discript.
Firmware data
e.g. 0
0006 Serial number e.g. 3
0007 Converter number e.g. 1
0
0008 EEPROM prog.
cycles 0 -
Displays the EEPROM programming cycles -1 ... 100000
0898 Data record number 0.000 2
Any numerical value, e.g. for archiving purposes can
be saved here. This value is saved in the EEprom so
that data is not lost during power failure. At load
factorySetting P0071 a specific value are setting
here. 0.000 ...
2147483.647
0899 Data record number 0.000 2
Any numerical value, e.g. for archiving purposes can
be saved here. This value is saved in the EEprom so
that data is not lost during power failure. At load
factorySetting P0071 a specific value are setting
here. 0.000 ...
2147483.647
Options
These are only displayed if the actual option is available. The parameters
are described in the associated option description.
8.5 Numerical list
All of the basic parameterization parameters can be directly selected in
the numerical list using the parameter number (refer to the structure of
the basic parameterization).