REXROTH IndraDyn A Series, Project Planning Manual

Page: 201 / 220

Rexroth IndraDyn A Operating IndraDyn A Motors
12-1
12 Operating IndraDyn A Motors
12.1 Commissioning
CAUTION
Material damage due to errors in activating
motors and moving elements! Unclear operating
states and product data!
⇒
Do not carry out commissioning if connections,
operating states or product data are unclear or faulty!
⇒
Do not carry out commissioning if the safety and
monitoring equipment of the system is damaged or
not in operation.
⇒
It is not allowed to operate with damaged products!
⇒
Contact Bosch Rexroth for missing information or
support during commissioning!
The following notes on commissioning refer to IndraDyn A motors as part
of a drive system with drive and control devices.
Preparation
1. Keep the documentation of all used products ready.
2. Log all measures taken in the commissioning log.
3. Check the products for damage.
4. Check all mechanical and electrical connections.
5. Activate the safety and monitoring equipment of the system.
Execution
When all prerequisites have been fulfilled, proceed as follows:
1. Activate the blower at the MAD or the external cooling system for
supply of the MAF motors, and check for regular condition. Consider
the notes of the manufacturer.
2. Carry out the commission of the drive-system according to the
instructions of the respective documentation. You can find the
respective information in the functional description of the drive-
controller.
3. Log all measures taken in the start-up report.
Commissioning of drive controllers and the control systems may
require additional steps. The inspection of the functioning and
performance of the systems is not part of the commissioning of the motor;
instead, it is carried out within the framework of the commissioning of the
entire machine. Observe the information and regulations of the machine
manufacturer.