For the project planning of a drive system with Smart Energy Mode, there is a
separate documentation. Write an e‑mail to
, if
you need this documentation (Indrv_HMV0xR_Smart_Energy_Mode_xx.pdf).
Parallel Operation HMV - Group Supply with DC Bus Connection HMV01, HMV02
Brief Description
"Group supply with DC bus connection" increases the available regenerative
power, the continuous braking resistor and infeeding power in the common
DC bus of several drive controllers.
This mains connection is mainly used to cover the power range above the
biggest modular supply unit.
Block Diagram
HMVxx.xE
Components marked with gray background color: Optional, depending
on the application
HMVxx.xR
Mains filter and mains choke: necessary
HMVxx.xR-
W0120
Mains filter, mains choke, external mains contactor: necessary
Fig.8-3:
Parallel Operation - Group Supply HMV With DC bus Connection
When dimensioning the fuses in the supply feeder and in branch‐
es, make sure to provide protection against overcurrent and over‐
load in the case of error.
See
chapter 15.3.5 "Dimensioning the Line Cross Sections and
Notes on Project Planning
Parallel operation of regenerative supply units HMV0x.xR is not
allowed!
Supply unit
Supply units at DC bus
HMV01.1E-W0030
Two of the same type
HMV01.1E-W0075
HMV01.1E-W0120
Bosch Rexroth AG
DOK-INDRV*-SYSTEM*****-PR06-EN-P
Rexroth IndraDrive Drive Systems with HMV01/02 HMS01/02, HMD01, HCS02/03
98/309
Configuring the Drive System
