REXROTH IndraDrive Fc FCS01, Operating Instructions Manual

Page: 63 / 238

Rexroth IndraDrive FCS01.1 Indications and Operation of the Function Modules
9-7
DOK-INDRV*--FCS01*****-IB01_EN-P
Parameterization with standard control panel
The parameterization of the frequency converter can be performed in
various operating states. Generally, all parameters can be changed
online. Depending on operating state and release source, there are
different ways to change to parameter mode.
•
When the frequency converter has been released via the standard
control panel (START key ), go to parameterization mode by
simultaneously pressing the START and ENTER keys + .
•
Change back into control mode by pressing the START key .
•
When no release has been given, or release has been given through
the control terminals or a serial interface, change into
parameterization mode directly from the operating value indication by
pressing the or keys.
P 0 _ _
/
P 7 _ _
•
To quit parameterization mode, press the key.
•
To change a parameter value , press the ENTER key when the
respective parameter number is indicated.Effect changes via the
or VALUE keys. Press to save and quit the parameter.
As long as a changed value has not been confirmed with "ENTER",
the value indication will flash; this means that the value has not yet
been saved in the converter.
During parameter setting, the indicated values do not flash for better
legibility.
If you do not wish to confirm a change, press the "DIRECTION" key
to quit the parameter.
Confirmation of
changed value
Increase value Reduce value
No confirmation of
changed value
Indic. of parameter block
Value to factory setting
Fig. 9-5: Control panels of the standard control panel