Risk of damaging the device if not expressly sta-
ted accessories, mounting parts and other com-
ponents, cables, lines and software and firm-
ware are used
NOTICE
The machine control panels may be used only as intended and with the accesso-
ries, mounting parts and other components specified in this documentation.
Components that are not expressly mentioned must neither be attached nor
connected. The same applies to cables and lines.
Only to be operated with the component configurations and combinations ex-
pressly defined and with the software and firmware specified in the correspond-
ing functional description.
The machine control panels IndraControl VAM 15.1/VAM 21.1 were developed
for the single-axis as well as for the multi-axis drive and control tasks.
For the application-specific use of the machine control panels IndraControl
VAM 15.1/VAM 21.1, device types are available in different variants.
Areas of application of the machine control panels IndraControl VAM 15.1/
VAM 21.1:
●
Lathes
●
Milling machines
●
Machining centers
The machine control panels of the IndraControl VAM 15.1/VAM 21.1 design may
only be operated under the assembly conditions and installation conditions, in
the specified position of use and under the specified ambient conditions (tem-
perature, degree of protection, humidity, EMC etc.) given in this documentation.
Device surface damage due to unapproved lu-
bricant and cleaner
NOTICE
Before use, check new lubricants or cleaners for compatibility with the material
of the devices.
5 Spare parts, accessories and wear parts
5.1 Connectors and ready-made cables
Sercos III
Ordering code
Part number
Description
RKB0013/00,19 (*******-*******-*******) R911329741 Bus cable, length 0.19 m, RJ45/RJ45 plug
RKB0013/00,25 (*******-*******-*******) R911317797 Bus cable, length 0.25 m, RJ45/RJ45 plug
Machine Control Panels
Bosch Rexroth AG
Spare parts, accessories and wear parts
DOK-SUPPL*-VAM*15*21*1-IT02-EN-P
5/53
