REXROTH IndraControl L25 CML...3N Series, Project Planning Manual

Page: 46 / 72

Fixing the end clamp / CLIPFIX Finally, attach end clamps to both sides of the Rexroth Inline station. These end
clamps ensure that the station is securely mounted to the top-hat rail and are
also provided as lateral termination elements. These end clamps are included
in the scope of delivery of the IndraControl L25.
8.1.3 Dismounting the IndraControl L25
Disconnecting additional modules
from the IndraControl L25
To dismount the IndraControl L25, first disconnect the function modules moun‐
ted to the left of the IndraControl L25 from the latter. First remove the left-hand
end clamp (CLIPFIX) and slide the function modules along the top-hat rail to
the left until the plug connection of the PCI PLUS bus is severed.
Removing the first Rexroth Inline
terminal
Thereafter, remove the first Rexroth Inline terminal that is mounted to the right
of the IndraControl L25. Proceed as follows:
●
Remove the labeling field, if present.
If any of the terminal is provided with more than one connector, all
these connectors have to be removed from the terminal.
● Pry out the connector of the terminal to be removed by pressing on the
rear connector shaft latch.
● Remove the connector(s).
● Remove the power connector from the IndraControl L25. This ensures that
the feathers of the voltage jumpers and of the keyway/feather key con‐
nection are prevented from damage. Moreover, the terminal can be ac‐
cessed more easily.
● Actuate the release mechanism (see ① in the following figure) and remove
the terminal perpendiculary to the top-hat rail (see ② in the following fig‐
ure).
Fig.8-1: The first Rexroth Inline terminal has to be removed before dismounting
the IndraControl L25.
Removing the IndraControl L25
from the top-hat rail
Now the IndraControl L25 can be removed from the top-hat rail by loosening
the fixing claw on the bottom side by means of a tool (screwdriver) and pulling
Bosch Rexroth AG DOK-CONTRL-IC*L25*****-PR03-EN-P
Rexroth IndraControl L25
44/69
Installation and Maintenance