REXROTH Fv Series, Instruction Manual

Page: 122 / 222

Group E1: Output Terminals
E1.00
Open collector output OUT1 Factory Default 1
Setting range 0 − 11 Minimum unit 1
E1.01
Open collector output OUT2 Factory Default 1
Setting range 0 − 11 Minimum unit 1
E1.02
Relay outputs Pa, Pb and Pc Factory Default 1
Setting range 0 − 11 Minimum unit 1
Open collector outputs OUT1 and OUT2 and the relay outputs are described
as below:
●
0: Converter is ready to run
–
Terminal output indicating signal when the converter is free of fault
and ready to run after the main circuit and the control circuit power
supplies have been established.
● 1: Converter is running
–
Terminal output indicating signal when the converter is running and
has frequency output.
● 2: DC brake indication
–
Terminal output indicating signal when the converter is in DC brak‐
ing process.
● 3: Converter runs at zero speed
–
Terminal output indicating signal when the converter runs at 0 Hz.
● 4: Frequency/speed arrival signal
–
See related parameter ‘Frequency arrival detection width’ [E1.03].
● 5: Frequency level detection signal (FDT1)
–
See related parameters [E1.04] − [E1.05].
● 6: Frequency level detection signal (FDT2)
–
See related parameters [E1.06] − [E1.07].
● 7: Simple PLC phase completion indication
–
Terminal pulse output indicating signal when each phase is com‐
plete in simple PLC control.
● 8: Under voltage stop
–
Terminal output indicating signal when the converter is at under
voltage.
● 9: Converter over load pre-warning
–
Terminal output indicating signal when the output current exceeds
the set value of parameter ‘Converter over load pre-warning level
setting’ [E1.08].
● 10: Motor over load pre-warning
–
Terminal output indicating signal when the output current exceeds
the set value of parameter ‘Motor over load pre-warning level set‐
ting’ [E1.09].
● 11: Over torque
–
Terminal output indicating signal when the motor torque exceeds
the set value of parameter ‘Torque limit’ [S1.02] in vector control.
Bosch Rexroth AG DOK-RCON02-FV*********IB01-EN-P
Rexroth Frequency Converter Fv
120/219
Parameter Settings