Band knife machine R750/R1000 – Instruction manual
Page
44 / 89
FPUH Rexel s.c.
ul. Radziwoja 11, 61-057 Poznań
tel.: +48 61 87 68 946
www.rexelpoland.com
DANGER
WARNING!!!
Never check for power cables and other electrical cables if there is a suspicion
that the cables may be connected to the power.
Risk of electric shock.
Check if the EMERGENCY STOP buttons are connected to the
machine and show no sign of damage.
Check if the MAIN SWITCH shows no sign of damage.
If any discrepancies are found during the commissioning, stop working
on the machine and secure it against accidental operation. Further work on the
machine will be possible after removing the defects.
DANGER
WARNING!!!
Never work on the machine if it is found that it does not meet the requirements
of this manual.
In the event that there are no contraindications it is allowed to start the
machine:
Turn MAIN SWITCH in position I (ON),
Perform other actions according to this instruction manual.
6.5.
U
SING THE MACHINE IN THE MANUFACTURING PROCESS
After preparation of the material layers or foam put it firmly near the
vicinity of the saw blade, so that a cut line is opposite the edge of the band.
Then, by rotating the handle on the side of the machine lower the guard so it is
not higher than 4 mm above the material. Then start the machine and start
cutting process, controlling material being very careful, do not place hands near
the blade. Cutting shapes should be done in arcs not less than 16 mm.
