RKF 130
Transport, setup, installation
Version 1.1
Page 27 of 128
3.5
ALIGNING THE MACHINE
The piston filler must be aligned horizontally to the location determined for it. This can be
done just by twisting it on the plastic feet. The machine feet must be turned by a maximum of
35 mm from the threaded connector end. All the four plastic feet must be on the floor after
the alignment is complete.
The height cannot be aligned if rollers have been installed!
3.6
SPACE REQUIRED FOR OPERATION AND MAINTENANCE
The piston filler must be easily accessible for cleaning and maintenance of all
sides. For this, a free space of at least 0.5 m to the piston filler from all sides is
necessary for this, alternatively sufficient free elbowroom is required such that the
necessary activities for operating, cleaning, maintaining and repairing as well as
replacing machine parts is not obstructed. In addition, ensure that the all the work
that comes up can be performed without any hindrances in the area of operation.
