Reverend Guitars
hellhound_manual.html[6/30/2015 11:36:47 AM]
Reverend Hellhound Amplifier Owner's Manual
CAUTION!
Do not open amp chassis - risk of fatal electrical shock.
No user serviceable parts inside amp.
Never operate in damp or wet conditions.
Tube and chassis surfaces very hot.
High volume use can cause permanent hearing damage - always use ear protection.
SET-UP PROCEDURE
INSTALL POWER TUBES - To prevent damage, power tubes are shipped in boxes inside
cabinet.
Lay amp face down on non-damaging surface. Be sure amp is unplugged.
Unscrew and remove back panel.
Install power tubes. Alignment pin protruding from center of tube MUST align with hole
in tube socket - pin has ridge that MUST align with groove in socket hole. Push tubes
in firmly.
Re-mount back panel.
POWER UP AMP
- Plug in amp. Turn VOL all the way down. Make sure speaker is
connected to speaker jack. Turn amp on. Amp is now ready to use.
READ ENTIRE OWNER'S MANUAL BEFORE OPERATING!
- Please read manual carefully
to achieve maximum performance and maintain safe operation of your amp.
FRONT CONTROL PANEL
ON
- Powers amp. WARNING: Always have a speaker connected to the amp before turning
on, otherwise serious damage could occur to amp! VOL should be turned all the way down
before turning amp on or off. Leave amp on during short break periods, simply turn down the
volume on your guitar or amp.
SCHIZO
- UK mode introduces an upper-midrange boost, similar to the classic British amps
with increased overdrive and note clarity. US mode has less midrange, similar to the classic
American amps with a cleaner, softer sound.
GAIN
- Controls the amount of overdrive. Higher settings produce more distortion, lower
settings produce a cleaner sound. GAIN will affect the volume level, but this can be adjusted
with the VOL control.
VOL
- Controls the overall volume. For the cleanest possible sound set VOL to maximum
and use the GAIN control as your volume control.
TREB
- Controls treble frequencies. TREB control is more responsive when the MID control
