INSTALLATION INSTRUCTIONS
for Top Mount Pull-Out Waste Containers with
Door Mounting Brackets
For Model: 4WCTM-27-4
Step 2:
Install front of slide to face
frame. Hole is placed
3
/
8
" from
front of cabinet. Bottom of
slide should be 13
1
/
8
" from
cabinet fl oor. Use #8 x
5
/
8
"
Low Profi le Truss Head Screw
Step 1:
Install rear bracket to
rear of slide.
Step 3:
If rear of cabinet is thin-
ner then
1
/
2
", install a
1
/
2
" x 3" wide furring
strip to the back of the
cabinet cenered 14
1
/
4
"
from fl oor of cabinet.
14
1
/
4
"
12
3
/
4
"
14
1
/
4
"
13
1
/
8
"
13
1
/
8
"
Step 4:
Measure from inside
cabinet wall to inside
face frame (A) distance
should be measured
the same at rear of
cabinet (B).
(A)
(B)
Cabinet Member
Slides
Step 5:
Mount Rear Bracket.
Extend the slide rear mounting
bracket until it contacts the rear
(Furring Strip). Bottom of slide
should be 13
1
/
8
" from cabinet
floor. Rear mounting bracket
should be the same distance
from the side cabinet wall at rear
of slide as it is up front. Drive mounting screw in center
horizontal slot of rear mounting bracket, tighten. Tighten
screw in front bracket.
Step 6:
Install wood unit (with slides attached) into cabinet, en-
gaging product member slides into cabinet member slides,
push unit until it locks in place.
Top View
Product Member
Cabinet Member
Rear Mounting Bracket
presure fi ts over end of slide.
Rear Bumper Stop
FW: I-WCTM150
For models: 4WCTM-12DM1, 4WCTM-15DM2, 4WCTM-18DM2
and 4WCTM-27-4
