SuperCleanox Operating instructions
Page
46
of 62
16.5 Workflow, polishing with carbon electrode
Workflow - polishing -
1
Polish the surface after cleaning.
2
Switch on the appliance.
The mains switch lights up.
3
Safety information
Never switch the appliance ON/OFF with the mains
switch repeatedly, in quick succession.
These appliances are equipped with an inrush
current limiting device, which prevents the circuit-
breaker triggering too quickly.
Switching on/off in quick succession may damage
the electronics in the appliance.
Wait at least 30 seconds after switching off before
switching the appliance on again.
4
SuperCleanox VI HD
Polishing with carbon electrode not possible
SuperCleanox VI
Select operating position "III".
Polishing with carbon electrode
The green LED lights up.
SuperCleanox IV+
Polishing with carbon electrode not possible
5
For polishing use our Polisher electrolyte.
6
The workflow for polishing is the same as for cleaning
7
Note
If required, you can seal the surface with our Neutralyt-Soft
(see catalogue).
The surface is less sensitive to new soiling,
e.g. fingerprints.
Prevents subsequent rusting on corrosion-sensitive
surfaces
For more information, see the tips for "cleaning" and "polishing".
Table
8 Workflow, polishing
