Page 69 of 72
©Retrotec Inc. 2012
Appendix F
: Setting up for a test with Alaska’s AkWarm
software
1.
Press
[Setup]
to enter the “Setup” menu
2.
Press
[
]
or
[
]
to scroll through the list until “Mode Setup” is highlighted
3.
Press
[Enter]
to enter the “Mode Setup” submenu
4.
Press
[
]
or
[
]
to scroll until “Pressure
”
is highlighted.
5.
Press
[
]
or
[
]
to scroll until “Pa
”
is displayed
6.
Press
[
]
to highlight “Flow
”
7.
Press
[
]
or
[
]
to scroll until “CFM
”
is displayed
8.
Press
[
]
once to highlight “EqLA
”
9.
Use
[
]
or
[
]
to scroll until “in
2
” or” ft
2
”
is displayed (this is an optional measurement
forAlaska AkWarm)
10.
Press
[
]
once to highlight “Air Change
”
11.
Use
[
]
or
[
]
to scroll until “On
”
is displayed (this is an optional measurement for Alaska
AkWarm)
12.
Scroll down to all other results in the Mode Setup menu, and use
[
]
or
[
]
to scroll until
“Off” is displayed to disable all other results.
13.
Press
[Exit]
once to return to the “Setup” submenu
14.
Press
[
]
to select “n
”
15.
Press
[Enter]
16.
Use the keypad to set this value to “0
.
65
”
17.
Press
[Enter]
to accept this value
18.
Press
[
]
to select “Power Down Hour
”
19.
Leave at “2
”
(hours) or set to “0
”
to turn auto-power-down off.
20.
Press
[
]
to select “Surface Area Unit
”
21.
Press
[
]
or
[
]
to set to “ft
2
”
(Note: AKWarm does not require the use of this parameter)
22.
Press
[
]
to select “Building Volume Unit
”
23.
Press
[
]
or
[
]
to set to “ft
3
”
(Note: when you select Air Changes, you will enter volume
in ft
3
)
24.
Press
[
]
to select “European , Separator
”
25.
Press
[
]
or
[
]
to set to “No
”
26.
Press
[
]
to select “Sig Figs
”
27.
Press
[
]
or
[
]
to set to “3.5”
28.
Press
[Exit]
to exit the “Setup” menu and save these Setup choices.
Your gauge is now set up for performing an Air Leakage Test with Alaska’s AKWarm Software.
