12
Copyright © 2017 Retro Manufacturing, LLC
INSTALLATION INSTRUCTIONS
NOTE: This unit re12 volts to both the red and yellow wires to operate properly.
Locate the three wiring harnesses: main wiring harness, power
wiring harness and speaker wiring harness (see “What’s in the Box”
on page 4). First connect the main wiring harness to the back of
the radio body. Then connect both the power and speaker wiring
harnesses to the black female plug of the main wiring harness.
Next, connect the bare wire ends of your power and speaker wires
to the appropriate power and speaker locations in your vehicle
(see Figure 5). Have your radio installed by a professional if this part
of the install is too difficult, or contact us if you have questions.
Bluetooth
®
Microphone
Your Bluetooth
®
microphone enables you to place hands-free
phone calls through your radio. The Bluetooth
®
microphone input
is located at the rear of the radio body. To use your Bluetooth
®
microphone, you will need plug it into the plug at the rear of the
radio body and route it to an accessible location such as the
A-pillar or the steering column.
Rear Auxiliary (AUX) Inputs
Two auxiliary inputs are located at the rear of the radio
body. These auxiliary inputs allow you to listen to any external
source with a standard headphone output. An example of
an external source would be a MP3 player, iPod
®
or iPhone
®
,
portable CD player or portable satellite radio receiver.
NOTE: If the auxiliary cables provided are not long enough, you may use our USB/AUX
Extension Cable (sold separately) to extend the reach of one cable. This cable also allows
the installation of one USB and auxiliary port into the factory location of the cigarette
lighter for a factory look and easy access. A male to male 3.5mm auxiliary cable is
required to connect your device to the auxiliary port on your radio.
