Resvent iHope RS Series, User Manual

Page: 81 / 261

5-7
5. System Settings
5.4 Basic Settings
5.4.1 Set T-insp/I:E
1. Select[
Setup
] → [
Vent
] → [
Setting
].
2. Set [ T-insp/I:E ] and toggle between [ T-insp ] and
[ I:E ] Based on [ T-insp/I:E ], adopt the corresponding
T-insp or I:E ventilation parameter settings for
ventilation modes (refer to Figure 5-7).
5.4.2 Set VT/IBW
1. Select[
Setup
] → [
Vent
] → [
Setting
].
2. Set [
VT/IBW
]: Set to an appropriate ratio. The
system will calculate the default tidal volume (VT) in
the ventilation mode depending on [
VT/IBW
].
5.4.3 Set IBW/Height
1. Select[
Setup
] → [
Vent
] → [
Setting
].
2. Set [
IBW/Height
] and toggle between [
IBW
] and
[
Height
]. When the ventilator is in the standby
mode, set the ideal body weight or height. The
system calculates default values of VT, f, and fapnea
in the ventilation mode automatically based on the
set IBW or height and gender(refer to Figure 5-7).
5.4.4 Set IV Apnea Mode
1. Select[
Setup
] → [
Vent
] → [
Setting
].
2. Set [
IV Apnea mode
]: [
Volume Control
] or [
Pressure
Control
].
In case of invasive ventilation, the settable apnea
ventilation control parameter is [ VT-apnea ], if [ IV Apnea
Mode ] is set to [ Volume Control ], while is [ ΔP-apnea ] if
[ IV Apnea Mode ] is set to [ Pressure Control ].