RE306_DSC-Compat_Tilt_Instructions
Page 1 of 3
16-May-14
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
Wireless
Security
Solutions
RE306
Tilt, DSC-Compatible
Features
•
Alarm for anything that tilts.
•
Useful for hatches, roll-up doors and even moveable assets.
•
Cover tamper.
•
Strong, reliable RF signal.
•
10-15 year battery life on CR123A battery.
•
Low Battery indication.
•
3.3x1.4x1.1 inches.
Key Instructions
•
Battery “+” faces towards spring.
•
Normal Mounting position (non-alarm):
Straight up with battery at bottom, tamper switch at top.
Mounting upside down will cause over-sensitivity and false
alarms.
•
Enrolling Tilt in DSC Panel:
Put panel in Wireless Enrollment Mode.
Start with Tilt in the NON-Alarm state (vertical, battery down).
Tilt the sensor that you want to enroll.
Confirm ESN, Enter Zone # and Zone Type on DSC Panel.
May also be enrolled via entering ESN.
Operation
•
Tilt
Alarm: When tilted more than 45 degrees from mounting position.
Tamper: when cover is opened.
Supervisory: every hour.
RE306_DSC-Compat_Tilt_Instructions
Page 2 of 3
16-May-14
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
Specifications
Tilt Alarm Angle:
45 d/- 15 degrees upwards cone
Tilt Operation Angles:
0 degrees (straight up) to 90 degrees (flat)
Tilt Element Technology: Stainless steel ball, non-mercury
Operational Life:
100,000 cycles
Mounting hardware:
# 4 or #6 screws
Replacement Battery:
CR123A 1550 mAH
Temperature Range:
0F to 120F
Housing dimensions:
3.3x1.4x1.1 inches
Specifications subject to change without notice.
Internal Picture
Shown in straight up, non-alarm mounting position.
Tilt Element
Non-Alarm
Cone
Non-Alarm
Cone
Alarm Cone
Alarm Cone
Do not use sensor in applications where the top
would tilt down into this region… even in alarm
Tamper Switch