DESKTOP OR SHELF MOUNTING:
Step1.
Attach the four adhesive rubber feet to the bottom of the first switch.
Attaching the Adhesive Rubber Feet
Step2.
Set the device on a flat surface near an AC power source, making sure there are
at least two inches of space on all sides for proper air flow.
Step3.
If installing a single switch only, go to “
” at the end
of this Chapter.
Step4.
If installing multiple switches, attach four adhesive feet to each one. Place each
device squarely on top of the one below, in any order.
INSTALLING AN
OPTIONAL SFP
TRANSCEIVER
You can install or remove a mini-GBIC SFP from a mini-GBIC slot
without having to power off the switch. Use only Manufacture
mini-GBIC.
N
OTE
:
The mini-GBIC slots are shared with the two 10/ 100/
1000Base-T RJ-45 ports. If a mini-GBIC is installed in a
slot, the associated RJ-45 port is disabled and cannot be
used.
Revision A1
10
