Replas 1800 Assembly Instructions Download Page 1

Page: 1 / 2

Premier Table 2 Support WCA FS

Assembly Instruc ons

1800 REPLAS

www.replas.com.au

If you require further assistance, please contact your supplier.

All dimensions are in millimetres (mm) unless speciﬁed.

4/11/2020

Ver 1 -

Parts List

Diagram

Instruc ons

Step 3:

Place the table support cross-arm into position and ﬁx with 2x75 mm bugle screws in each end

through the supports.

Step 2:

Secure the table supports to the mounting plate by ﬁxing 2x100 mm bugle screws in the outer

holes of each support. Then ﬁxing 2x125 mm bugle screws in the inner ﬁxing holes. (Closer to the
support upright)

Step 1:

Place the table supports into position, aligning the ﬁxing holes in the supports with the pre-drilled

We recommend assembling our products on a ﬂat surface, taking care not to damage the plas c.

holes in the support mounting plate. Ensure that the counter sunk cross-arm ﬁxing holes are facing
outwards.

Table Top

(x1)

Table Support

(x2)

Table Cross-Arm

(x1)

75 mm Bugle Screw

(x4)

100 mm Bugle Screw

(x4)

125 mm Bugle Screw

(x4)

Summary of Contents for 1800

Page 2: ... millimetres mm unless speciﬁed Ver 1 Parts List Diagram Instruc ons We recommend assembling our products on a ﬂat surface taking care not to damage the plas c Step 2 Secure the supports with the supplied 75 mm hex screws Step 1 Place the supports into position on the bench over the pre drilled holes Bench Top x1 Bench Support x2 x3 x5 75 mm Hex Screw x8 x15 x25 ...