Trinity-100 Lite Series Quick Start Guide
The full manual can be retrieved from
http://www.repeatit.se/support/trinity/trinity100lite.html
Before you start climbing verify that the equipment works on the ground. Power up both units
and put them between your computer and network access, you should have full communication
within a few minutes of powering up the units. (If the units have no internal antenna make sure
you place the antenna connectors directly opposite each other.)
The units are pre-configured and paired from factory with the following parameters.
Master
Client
IP address
10.0.0.1
10.0.0.2
Username
admin
admin
Password
public
public
Setting up the link
•
Mount the first unit, point it towards the site of the second unit. Power it up and make sure
the Power LED is lit and the status LED blinks slowly.
•
Mount the second unit. Power it up and adjust it for best signal using the status LED.
•
Adjust the first unit for best signal using the Status LED.
•
Make sure all cables are secured and connect the link to the network.
•
Configure the distance parameters at the master unit to reflect the correct distance between
the units.
Note
Make sure that the polarization on both units are in the same direction. Unaligned
polarization will significantly reduce the signal strength.
Package contents
Trinity-100 Lite
Trinity-116 Lite
Trinity-123 Lite
2 Trinity-100 Lite units
with N-female antenna
connector
2 Mounting kits
2 PoE with power adapter
for your local region.
2 IP65 RJ-45 connectors.
2 Trinity-116 Lite units
with integrated 16 dBi
antenna.
2 Mounting kits.
2 PoE with power adapter
for your local region.
2 Trinity-123 Lite units
with integrated 23 dBi
antenna.
2 Mounting kits.
2 PoE with power adapter
for your local region.
2 IP65 RJ-45 connectors.
Repeatit AB
Tel: +46 8 570 106 66
Hamngatan 33
Fax: +46 8 570 106 67
172 66 Sundbyberg
E-mail: [email protected]
Sweden
www.repeatit.se