PR-5000 with weight s lat attachment
parts Included:
2 Uprights
4 Horizontal Braces
8 weight horns
Hardware Included:
4.3 In Bolt
x 24
Nut
x 24
Small Washer
x 44
Bulgy Screw
x 16
1.
If you are starting from an
already assembled rack, remove
the name plate to make room for
the weight storage. If you are
starting with building your
power rack, full PR-5000 Power
Rack Assembly Instructions
available at repfitness.com.
Upright caps must also be
removed so that you can
properly secure any horizontal
braces at the highest point of the
uprights.
Attach horizontal braces to
the top and bottom of each
side of the back of the power
rack. These should be
attached to the highest and
lowest holes of the uprights.
The same screw will be used
that is securing the
horizontal braces of the
power rack.
x4
x8
x4
2.
Connect uprights to horizontal braces.
3.
(4.7 in)
x4
x8
x4
(4.3 in)
Weight Storage Parts + Hardware