3.5
System installation
Mounting the probe on a shank
1
3
2
× 2
NOTE:
Where the RMP600 is to be used with a shank switch, remove the plug from the rear of the
probe using pliers and replace it with the bobbin (A-4038-0303).
Bobbin
(A-4038-0303)
2.5 mm A/F
× 2
4 mm A/F
× 2
2.0 Nm – 3.0 Nm
(1.50 lbf.ft – 2.20 lbf.ft)
