© Renfert GmbH TM 04/02
Vario 3 waxing unit
No. 1456-0000 and 1456-1000
Areas of Caution
• Before switching on check that the unit's voltage matches the main power supply.
• Units with faulty leads or other defects should not be used.
• Do not cover the power units when in use.
• The compartments can get hot!
• Do not place anything on the lid as, depending on the set temperature, it can also get hot.
• Use only warm wax in the
Vario 3
.
• Do not apply a separate heat source (e.g. a flame).
• Never connect your
Vario 3
waxing unit directly to the mains supply: Always use the transformer
supplied.
• Clean the compartments (refer to “Maintenance”) and half fill them with the desired
Pico
waxes.
Please note: Overfilling the compartments may cause the wax to spill over! Also, if the compart-
ments are too full, different temperature zone will be created in the wax, thus making waxing-up
more difficult.
• Unroll both cables of the power supply, in order to avoid an overheating in case of short circuit.
• The cables of the power supply must not be shortened.
Cleaning / Maintenance
Your
Vario 3 waxing unit requires no maintenance. It should be cleaned from time to time. Use all the
wax in the compartment and then wipe it with a cloth or a cellulose duster. Set the unit to its lowest
temperature. You could get burned!
