QuickStart Guide
YRPBRL78G14
1. Installation
The installation of the demonstration files and GUI will be automatically performed by the DVD installer. If the DVD does not autostart, please run the “Setup” executable
file on the DVD and follow the directions for the installation. Please note that the user will require administration rights to the host PC in order to install the demonstration
and tool software.
2. Connection
1.
First ensure that a jumper is fitted on CN4 and that the YRPBRL78G14 stick jumpers are configured as shown below.
Jumpers
Configuration
CN8
2-3
CN7
2-3
CN6
2-3
CN11
2-3
2.
Next connect the YRPBRL78G14 USB stick to the host PC using the USB cable provided and when the USB stick is connected, diode D1 should be on, indicating
that power is supplied to the YRPBRL78G14 Stick.
3.
If this is the first time the USB stick is connected to the host PC, the drivers will be installed automatically. Accept any permission dialogs that arise. On completion
the driver should be “Renesas Starter Kit Virtual UART”. This can be verified by in the Device Manager and note the “com” port assigned to the USB stick.
YRPBRL78G14 Quick Start Guide
D010744_11
1
