Reference Boards of RZ/G2H, RZ/G2M, RZ/G2N, and RZ/G2E
Start-up Guide
R01US0555EJ0100 Rev.1.00
Page 4 of 13
Mar. 31, 2022
1. Hoperun Technology HiHope RZ/G2[HMN] platform (hihope-rzg2h, hihope-
rzg2m, hihope-rzg2n)
1.1
Preparation
1.1.1
Building files to write
This board uses the files below as a bootloader. Please build them according to the Release Note and copy these files to
the PC which runs a serial terminal software.
•
bootparam_sa0.srec
•
bl2-hihope-rzg2h.srec (RZ/G2H) or bl2-hihope-rzg2m.srec (RZ/G2M) or bl2-hihope-rzg2n.srec (RZ/G2N)
•
cert_header_sa6.srec
•
bl31-hihope-rzg2h.srec (RZ/G2H) or bl31-hihope-rzg2m.srec (RZ/G2M) or bl31-hihope-rzg2n.srec (RZ/G2N)
•
u-boot-elf-hihope-rzg2h.srec (RZ/G2H) or u-boot-elf-hihope-rzg2m.srec (RZ/G2M) or u-boot-elf-hihope-
rzg2n.srec (RZ/G2N)
1.1.2
Settings
Connect between the board and a control PC by USB serial cable according to the Release Note.
Set the settings about serial communication protocol on a terminal software as below:
•
Speed: 115200 bps
•
Data: 8bit
•
Parity: None
•
Stop bit: 1bit
•
Flow control: None
To set the board to SCIF Download mode, set the SW1002 as below:
SW1002
8
7
6
5
4
3
2
1
OFF
OFF
OFF
OFF
ON
ON
ON
ON
Note) Be careful not to change the SW1001 and SW1003
