R11UM0156EJ0240 Rev.2.40
Page 47 of 82
Jul. 28, 2020
PRIME v1.4 Base Node Tool
User Manual
Renesas Electronics Group Confidential
3
.
PC Tool operation procedure
PRELIMINARY
Notice This is not a final specification. Some
parametric limits are Subject to change.
(8) Select COM Port BN is connected.
If the following warning message is popped up, please set all options to enable.
Figure 3.37 The Settings for the Warning Dialog
(9) Status LED turns ON (immediately COM Port selected).
(10) Connect other Service Nodes.
(11) SNs are automatically perform registration.
3.9.3
Data Transmission Setting
Several parameters for Data Transmission are enabled.
-
Priority
is specified in PRIME spec and it specifies the timing of sending data to Power Line.
(Recommended value is 3).
-
Modulation
specifies a modulation type of each data-packet.
“AUTO” means that modulation is
updated according to the robustness management.
Attention: This setting can be applied when BN does NOT transmit/receive Data packet. It’s
better to select modulation when BN booted, and no SN is registered.
